1. Machine Overview

The 12036DY pairs the GT36 line’s 12,000 W source with the D-series configuration of the extended 12036 platform. Series hardware is shared: 80 rpm / 0.8 G chuck, two-chuck motor avoidance with 20–45 mm tail waste, cross-mounted dust-proof guide rails, and the side-hung structure with integrated automatic loading. As with the other 12,000 W models, the manufacturer publishes no cutting chart for this unit; process capability is quoted per application.

2. Key Advantages

• 12,000 W power class — heavy-wall structural tube cutting.
• Φ20–360 mm tube range — round, square, oval and special profiles.
• Five-tube continuous loading, 40–60 s cycle.
• 20–45 mm tail waste via two-chuck motor avoidance.
• 600 °C annealed welded bed on the extended platform.

3. Welded, Stress-Relieved Machine Bed

Welded plate-and-tube construction, stress-relieved at 600 °C for 4.5 hours with furnace cooling, then rough- and finish-machined. The stabilized bed keeps axis geometry true under the loads of heavy-wall, high-power cutting.

4. Automatic Loading on the Side-Hung Structure

The side-hung (cantilever) cutting structure is integrated with the automatic loading machine, feeding five tubes continuously on a 40–60 s cycle sized for heavy stock.

5. Cutting Performance

The manufacturer does not publish a 12,000 W cutting chart for the 12036DY. Cutting capability (material, thickness, speed) is quoted per application against your drawings — full 12,000 W cutting charts and process validation are available on request.

6. Power, Cooling and Gas Supply

Power, cooling-water and assist-gas requirements follow the heavy-series specification; site preparation details are provided with the quotation. Full utility requirements available on request.

7. Key component configuration

Entries for the chuck (GL360 triple chuck, hydraulic) and the support-rack load capacity (1200 kg) are marked in red on the factory specification sheet; the red marking is reproduced here as an explicit note.